1

00:00:03,066 --> 00:00:06,033

Hello everyone, today I will show you how to delaminate

2

00:00:06,033 --> 00:00:08,300

the two-layer mainboard of the iphone series

3

00:00:13,733 --> 00:00:16,000

I'm holding an iphone 13 mainboard

4

00:00:19,333 --> 00:00:24,166

We first need to rip off the foam strip next to the plastic seat before we delaminate

5

00:00:39,066 --> 00:00:43,566

Then there is a black sticker on the side of the iphone 13, rip it off

6

00:00:54,066 --> 00:00:57,566

Then put the mainboard on this dedicated layered heating table,

7

00:00:57,733 --> 00:00:59,166

and put it smoothly

8

00:01:03,333 --> 00:01:06,366

There may be some stickers on the back that make it unstable,

9

00:01:06,800 --> 00:01:08,066

we'd better take it off

10

00:01:28,300 --> 00:01:29,666

The mainboard is stable

11

00:01:31,066 --> 00:01:32,400

After it is stable,

12

00:01:32,533 --> 00:01:34,866

we turn on the switch of the heating table,

13

00:01:38,500 --> 00:01:42,166

The heating table manufacturer recommends that the layering temperature

14

00:01:42,166 --> 00:01:46,266

of the iPhone 13 and 13 mini is 230 degrees

15

00:01:48,800 --> 00:01:53,300

We set the temperature to 230 degrees and wait for it to heat up

16

00:01:57,300 --> 00:02:00,833

After heating to the set temperature, we start layering

17

00:02:03,133 --> 00:02:05,966

In order to facilitate the layering operation,

18

00:02:05,966 --> 00:02:09,900

you can find a small screw that matches the screw hole on the mainboard,

19

00:02:10,000 --> 00:02:11,533

a slightly longer one,

20

00:02:14,000 --> 00:02:16,566

and install it on one of the screw holes,

21

00:02:16,666 --> 00:02:18,866

so that we can separate it later

22

00:02:22,300 --> 00:02:25,500

Just tighten the screw, don't twist it too hard,

23

00:02:27,000 --> 00:02:30,066

if you twist it too hard, it may crush the mainboard