1

00:00:03,233 --> 00:00:07,500

Next we start prying the chip

2

00:00:09,966 --> 00:00:16,133

Adjust the temperature of the rotary air gun to about 340 degrees,

3

00:00:17,000 --> 00:00:24,133

which is about 20 degrees higher than the temperature when we usually disassemble the iPhone chip

4

00:00:32,666 --> 00:00:35,800

Some chips are particularly vulnerable to damage

5

00:00:36,166 --> 00:00:40,100

When we disassemble the font chip, in order to prevent problems with the chip,

6

00:00:40,400 --> 00:00:43,566

we can also lower the temperature and bake it for a while

7

00:00:45,600 --> 00:00:49,200

For example, the temperature of the edge scraping glue we just had is 200 degrees.

8

00:00:49,566 --> 00:00:53,233

Then turn on the air volume to the maximum, bake it for a while, preheat it,

9

00:00:53,666 --> 00:00:56,133

and raise the temperature of this area of the mainboard

10

00:01:49,366 --> 00:01:55,300

Bake for at least 2 minutes

11

00:01:56,466 --> 00:02:02,533

You don't blow for 10 seconds and start prying

12

00:02:03,333 --> 00:02:10,333

In this case, preheating is basically meaningless.

13

00:02:15,733 --> 00:02:20,066

Android has many models without drawings

14

00:02:20,300 --> 00:02:27,500

Let's first place one foot at this position, facing this position, and make a mark on it

15

00:02:28,400 --> 00:02:35,500

When we install the chip, we will know the direction of the foot

16

00:02:51,166 --> 00:02:54,633

About 2 minutes now

17

00:02:57,266 --> 00:03:06,800

Let's adjust the temperature, around 340, and adjust the air volume to 3 to 4 gears

18

00:03:12,066 --> 00:03:21,333

The blade slowly tried to poke the font chip from the side edge

19

00:03:24,666 --> 00:03:31,666

Once the blade is poked in, never twist the blade

20

00:03:33,433 --> 00:03:44,000

Just slowly plug it in, let the chip fall off automatically

21

00:04:30,066 --> 00:04:34,900

OK, the chip is disassembled