1

00:00:03,000 --> 00:00:05,000

Next we start tin planting

2

00:00:07,633 --> 00:00:09,300

Clean the chip first

3

00:00:44,833 --> 00:00:49,166

For the font chip, we try to use a dedicated steel mesh

4

00:00:52,200 --> 00:00:56,900

For other chips on Android, we can use that kind of universal network

5

00:00:56,900 --> 00:01:00,966

Try to use this dedicated stencil for fonts

6

00:01:00,966 --> 00:01:08,966

Because some font chips have a lot of gold-plated points on the side edges

7

00:01:08,966 --> 00:01:13,700

For example, there are many gold-plated spots in this area.

8

00:01:13,900 --> 00:01:20,400

If you use a universal net, after putting it on, the gold-plated point will leak out

9

00:01:20,400 --> 00:01:22,066

It may stick to the tin when it is planted

10

00:01:22,066 --> 00:01:25,233

In fact, the useful point is in the square area in the middle

11

00:01:25,500 --> 00:01:28,900

But if tin sticks to the side, you have to clean it up, which will be troublesome

12

00:01:29,266 --> 00:01:32,100

Therefore, a special steel mesh is used when the font chip is tinned.

13

00:01:38,833 --> 00:01:43,766

Use 183 medium temperature tin

14

00:02:23,233 --> 00:02:28,133

The temperature of tin planting is adjusted to about 230 degrees, and the rotating wind

15

00:02:33,800 --> 00:02:36,133

Scan first, warm up

16

00:02:49,666 --> 00:02:51,566

Warm up for about 1 minute

17

00:02:53,000 --> 00:02:54,866

We blow it from a corner

18

00:03:08,766 --> 00:03:12,600

After blowing completely, remove the air gun

19

00:03:13,366 --> 00:03:20,033

Wait for 10 seconds, press the chip from the back with tweezers

20

00:03:22,100 --> 00:03:26,666

In this way, the tin planting of this chip will be handled.